Ventless gas fireplace repair for homes in Lauderhill
You get a written record of what we cleaned, measured and replaced on your vent-free unit.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs a ventless gas fireplace needs service
- Unit shuts off after running a while
- Pilot lights but burner will not
- Moisture on windows while it runs
- Pilot hard to light after gas work
Jump to
Repairing a ventless unit without bypassing its safety pilot
Start a ventless repair at the rating plate
Every vent-free fireplace and log set carries a rating plate. It names the model, the gas it burns and the standard it was listed to. We read it before we open anything, because the manual, the parts list and the room rules all follow from that plate.
If you can see the plate in Lauderhill without moving logs or panels, read the model to us when you book. Leave the plate and any warning tags attached. The manuals ask that they stay on the appliance, and a unit with an unreadable plate is harder to service within its listing.
Spark at the gas pilot but no flame
A spark without a flame means gas is not reaching the pilot in the right amount. After a long idle stretch or new work on the gas line, air in the line is common, and the manual describes a purge. A blocked pilot orifice, a closed supply valve or low pressure are other causes.
We confirm which it is rather than guessing. Please do not keep sparking for minutes on end, and do not open fittings to check for gas. Leave those steps to the visit, where each one can be done in order.
Clearing the ports on a vent-free burner
Gas leaves a vent-free burner through rows of small ports. Dust and lint settle into them over time, and the flame pattern changes where they close up. Uneven flames and soot often start here.
During service we clear the ports without enlarging them, using methods the manual allows. Then we light the burner and check that flame runs evenly along its length. If a burner is cracked or warped rather than dirty, we show you and list the replacement as a separate item.
A second look at an unrepairable ventless unit
If another company told you the vent-free unit cannot be repaired, a second look is reasonable. We start from the rating plate and the manual, not from the earlier verdict. Sometimes the earlier view is right, and we say so without trying to sell a different answer.
Where a listed repair is possible, the estimate explains it line by line. Where it is not, we explain the reason in plain words, whether parts, the host fireplace or the room. You get a clear answer either way, and a written record of what we checked.
Where the ventless repair scope starts and stops
- Burner primary air opening cleaned
- Host fireplace listing for vent-free logs
- Leak check on disturbed joints
- Lighting sequence shown to you
Before your vent-free fireplace visit
What should I do if I smell gas near the unit?
Leave the house with everyone inside, without lighting anything or touching switches. Once you are outdoors, call your gas utility or 911 and follow their instructions. Stay out until they clear the house, and keep the fireplace off afterward.
Can a vent-free log set go into any prefab fireplace?
Only into a factory-built fireplace listed and labeled for unvented gas logs. The Florida Building Code says so, and some fireplace manuals state they were not tested with them. We read both labels before servicing the logs.
Why does a new log set smell when it first burns?
New logs and parts carry oils and binders that burn off during a break-in period, and the manuals call for plenty of ventilation then. If smoke or odor continues well past that stage, turn the unit off and tell us.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo