Ventless gas logs, pilots and burners repaired in Miami Springs
The ODS pilot is cleaned, tested and replaced only with the listed part for your burner system.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs a ventless gas fireplace needs service
- Unit shuts off after running a while
- Flames orange, stringy or lazy
- Roaring or whistling from the burner
- Moisture on windows while it runs
Jump to
Repairing a ventless unit without bypassing its safety pilot
Cleaning an ODS pilot the maker's way
Cleaning an oxygen depletion sensor pilot follows a set order in the manuals. The unit is off and cool. Loose dust is brushed lightly while a vacuum draws it away, so nothing falls into the pilot opening. The air intakes are then cleared with compressed air.
Where the maker describes it, the pilot supply line is also cleared in the direction the gas flows. After reassembly, every joint we disturbed gets a leak check, and the pilot is lit and watched. You see the flame before we call the cleaning finished.
Thermostats and burner cycling on vent-free units
With a thermostat control, a vent-free burner cycles on and off, or up and down, as the room warms. That is normal, and the pilot stays lit through it. A burner that cycles off early can point to a sensor placed in the wrong spot or a setting that needs a look.
We check how the thermostat is set and where its sensor sits. Then we compare the cycling with the manual's description. If the unit is doing what it should, we explain that, and nothing is replaced.
Delayed or rough lighting of a vent-free burner
The main burner should light smoothly across its length. A delay followed by a soft thump, or flame that rolls out, is worth a call. The manuals list causes such as blocked ports, a log or ember near the pilot and low pressure.
Stop using the unit until it is checked. We clear the ports, reset any piece that blocks the path from pilot to burner and confirm pressure. Then we light it several times while you watch, so you can see the smooth lighting the manual describes.
Paint and finishes inside a ventless host fireplace
One log set manual lists paint or soot inside the fireplace among the things that influence how the burner and its pilot run. A freshly painted firebox can give off odors as it heats. Finishes near the opening can also discolor when the setup is not right.
If the fireplace was painted or refinished recently, tell us what was used and when. We check the clearances and the flame, and we explain whether the finish or the burner needs attention. Refinishing is not our work, so we name it as a separate trade if needed.
Ventless gas fireplace work, item by item
- Main burner orifice size and condition
- Remote, receiver and batteries tested
- Control compartment cleaned
- Lighting sequence shown to you
Ventless fireplace service questions, answered plainly
Can the oxygen depletion sensor be adjusted or bypassed?
No. The manuals forbid adjusting or tampering with the ODS pilot. When it misbehaves, it is cleaned as the maker describes or replaced with the same listed model. A unit that cannot be made right stays off until it can.
Why does the flame on my log set look orange and stringy?
One common cause is too much ember material on the burner. Manuals ask for a light, fluffy layer, kept away from the pilot and the large ports. Dirty air openings and drafts can do it too, and we check each.
Do you service vent-free log sets as well as complete units?
Yes. We service self-contained vent-free fireplaces and vent-free log sets in existing fireplaces. For a log set, we also check the host fireplace, its damper and its clearances, because the listing covers the combination.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo