Skip to content
(645) 465-4171

Spalling brick repair for chimney faces in Melrose Manors

New brick goes in after we have looked for what damaged the old units.

  • Owned and run locally
  • Available for same-day service
  • Fully licensed and insured
  • Family owned and run

Signs of brick damage on chimneys in Melrose Manors

  • Corners broken off several bricks
  • Bricks that look loose or pushed out
  • Spalled brick just above the roofline
  • A clear sealer flaking off the brick
Jump to

Spalled brick replacement, explained plainly

Keeping people clear of falling fragments

Spalled brick sheds pieces, and pieces falling from a chimney can hurt someone. If you see fragments landing on a path, a patio or the drive, keep people and pets away from that area until the chimney has been looked at.

Tell us where the pieces are landing when you call. It helps us judge how active the damage is and plan the visit. During the work, we protect the area below the chimney and explain where it is safe to walk.

Brick findings explained on site in Melrose Manors

After a brick inspection in Melrose Manors, we talk you through what we found before we leave. We point out which units have lost their face, which are cracked or loose and what seems to be sending water into them.

If you can see the chimney from the yard, we show you the areas. Ask anything that is unclear. The written estimate that follows lists the same units and reasons, so what you heard on site and what you read later match.

Booking chimney brick replacement in Melrose Manors

To book brick work in Melrose Manors, phone us or use the form on this page. Describe the damage you have seen, and we arrange a free inspection at a time that suits your household. You do not need to do anything on the roof.

During the visit, we check the brick and the parts that send water into it, then explain the findings. You receive a written estimate listing each unit. Services you approve inside 72 hours of that free inspection come with a 10% discount.

Appliances venting into the chimney during brick work

A chimney may serve a furnace or water heater as well as the fireplace. Its flue must stay open and clear while brick work goes on, even when the new units sit close to it.

Tell us about any appliance connected to the chimney when you book. We plan the work so its flue is not blocked and debris is kept out of it. Servicing the appliance itself is outside brick replacement, and we explain if anything we see needs another trade.

The brick replacement items you approve

  • Color, texture and range compared
  • Careful cutting of surrounding mortar
  • Surfaces dampened before setting
  • Mortar suited to the existing joints

Spalling brick repair questions from Melrose Manors

Why do the faces of chimney bricks come away?

Usually because water gets into the brick and something stops it drying out through the joints. Soluble salts can crystallize under the face, and hard mortar or a film coating can make it worse. We look for the source before replacing units.

Will new bricks stop water getting into the house?

They can close an entry point where broken brick lets water in. Water can also enter through the crown, flashing or joints. We explain what the brick work addresses, and a hose water test comes into it only if the job calls for one.

Does the fireplace need to stay unused during brick replacement?

Sometimes, while mortar around the new units cures and while any opening near the flue is closed up. Where the new bricks sit decides how long, and we give you a clear point to resume fires.

Proudly American

Family owned and operated in Miami, Florida.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Send your details for a free Miami chimney or fireplace inspection. We will call to confirm the appointment.

Chimney & Fireplace Brands We Work With