Fireplace insert installers serving homes in Plantation
Fireplace insert installation for homes in Plantation, planned around the host fireplace and the insert's own manual.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs your fireplace is ready for a wood insert
- A masonry fireplace sitting unused
- A fireplace you want closed up neatly
- A loose or missing liner cap
- A hearth too short for an insert
Jump to
Installing a wood insert the way its manual intends
The faceplate that closes the opening
A faceplate, sometimes called a surround, covers the gap between the insert and the fireplace opening. It gives a finished look and closes off the opening around the unit, as the manual intends. Most inserts offer more than one faceplate size.
We measure the opening and the face around it to choose a faceplate that covers the gap fully. The panels are fitted to the insert before it slides into place, as the manual describes. A faceplate that is too small leaves an opening that should not be there.
Signs of overfiring in an insert
Manuals warn that if the body of the insert, the chimney connector or the baffle begins to glow, the unit is overfiring. The advice is to stop adding fuel and close the air control until the glow subsides. Overfiring can warp steel and void the warranty.
We explain what a normal fire looks like in your insert and what counts as too much. Large loads of small, very dry wood with the air wide open are a common route to overfiring. If you see the signs, follow the manual and ask us to check the unit afterward.
Local officials and insert installations
An insert manual may tell owners to check with building or fire officials about local restrictions and whether an installation inspection is expected. Answers differ from one job and jurisdiction to the next, so we treat each insert project on its own facts.
Raise the question of review at the free inspection, and we explain how it could shape the schedule. Where an inspection must happen before the first fire, we tell you when and what the inspector is likely to look at. Lighting the insert waits until that step is complete.
Reloading without smoke in the room
Opening the door of a burning insert can let smoke roll out if the draft is weak. Manuals describe a simple fix, which is to open the air control fully for a short time, then open the door slowly, a crack first. The fire settles before the door opens wide.
We show you that routine with your insert at handover. Rake the coals, load the wood as the manual shows and close the door promptly. If smoke still escapes during reloading, tell us, because it may point to a draft issue worth checking.
What your insert installation scope lists
- Faceplate panels and insulation strips
- Baffles and smoke deflector in place
- Debris cleanup and haul-away
- Removal of an old insert if present
Wood insert questions from homes in Plantation
Will my existing hearth be large enough for an insert?
It depends on the model and how high it sits. Manuals set the size and thermal rating of the floor protection in front of the unit. We measure your hearth and explain whether it can stay, needs extending or needs added protection.
Why does the new insert smell during its early fires?
The high-temperature paint cures during the break-in fires and gives off an odor, which manuals describe as expected. Keep those fires moderate, ventilate the room and set nothing on top of the insert until the curing is done.
What does the free inspection include for an insert in Plantation?
We look at the masonry fireplace, the smoke chamber, the damper, the chimney and flue, the hearth and the trim around the opening. We also check roof access for the liner work and measure the opening in three directions.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo