Direct vent fireplace repair for Croissant Park homes
A written scope separates vent repair from any appliance fault we find along the way.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When the gas fireplace vent is the suspect
- Rust on exposed vent pipe
- Ceiling stain near a vertical vent
- Fire behaves oddly when fans run
- A porch enclosed around the termination
Jump to
Keeping a gas fireplace vent sound
Rerouting a vent to suit other building plans
Sometimes a vent has to move because of other work, such as a new addition, a remodeled room or a changed roofline. The new route must still fit the appliance's vent tables, termination rules and clearances.
Share the building plans with us early. We look at where the vent could go and what the tables allow, then give the builder the route and clearances. Planning the vent with the other work avoids opening finished walls later, and the vent work is priced as its own item.
Relocking and resealing vent joints
Vent joints rely on their locking features and, for some systems, a specified sealant at certain points. A joint that has loosened, lost its sealant or was assembled wrongly can leak or separate over time.
We disassemble accessible joints where needed, check the ends for damage and reassemble them as the instructions show. Damaged ends mean a new section. Sealant is applied only where the vent maker calls for it, with the product it names, because extra sealant can hide a poor joint rather than fix it.
Cleaning up after vent work
Vent work can involve attic dust, insulation, old pipe, sealant and packaging. We protect floors and furniture along the route through the house and keep insulation where it belongs.
Removed pipe and caps leave with us, or stay with you if you ask. Debris from the attic, the roof and the room is cleaned up and hauled away. If an access opening is left for a finish trade to close, we make it tidy and safe and tell you what remains to be done.
A vent route review before walls close
Another installer or a builder may be fitting your gas fireplace vent. If you want it checked before the walls close, we can review the route against the appliance manual, the vent instructions and the code's clearance table.
We look at the parts, the route against the vent tables, the supports, the firestops and the termination position. Findings are written up so the installer can act on them. We do not take over someone else's installation without agreement, but a review at rough-in costs far less than opening a finished wall.
What a gas vent visit in Croissant Park includes
- Termination clearances against the manual
- Supports, straps and wall bands
- Wall penetration seal
- Access opening and restoration priced separately
Gas venting questions for Croissant Park homes
Is a manual damper allowed in a gas vent?
Not in the vent connector. The fuel gas code prohibits manually operated dampers there, because a closed damper could stop the vent working. Listed automatically operated vent dampers are a different matter and follow their own instructions.
Can Type B vent be used on any gas appliance?
No. The vent maker lists Type B vent for appliances with draft hoods and others listed for Type B vent. It is not for appliances that can be converted to burn solid or liquid fuels. The appliance manual confirms which vent applies.
What should I do if a carbon monoxide alarm goes off?
Get everyone outside into fresh air, then call 911 from there. Stay out until the responders allow you back in, and leave the fireplace off until the vent and appliance have been inspected.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo