Stone chimney repair for a home in Homestead
A free inspection shows whether your stone chimney needs repointing, resetting or backing repair.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Joint and stone symptoms that point to water
- Stones missing from the chimney face
- Damp patches that linger on the stone
- White deposits washing out of the joints
- Stone buried in the roofing at the base
Jump to
Stone chimney repair, from backing to joints
How a loose stone is reset
Resetting starts with cleaning. Old mortar comes off the back of the stone and off the surface it will sit on, so the new bed has something clean to grip. The setting surface is dampened as the mortar maker directs.
The stone goes back in a full bed of mortar and is pressed until mortar squeezes out at its edges. The joints are then filled and tooled to match. A stone set this way is held across its whole back, not at a few points. Instructions for one manufactured stone say a disturbed stone must come out, be cleaned and be set again rather than pushed back.
Mortar that gives way before the stone does
Repointing mortar should be softer and more vapor-permeable than the masonry around it. That is the central point of the National Park Service guidance on repointing. If the joint is harder than the stone, stress and moisture move into the stone instead.
Softer stones then crack or flake at their edges while the hard joint stays intact. We choose a mortar suited to the stone on your chimney, and the estimate describes it in plain words. Strength alone is not the goal, because a joint is meant to be the part that wears.
Open joints in the upper courses
The joints nearest the top of a stone chimney take the most rain and wind. They are often the first to open, and water that enters there can run down through the chimney behind the stone face.
We give the upper joints close attention during the inspection. Repointing them is often one of the most useful repairs on a stone chimney. If the top above them sheds water poorly, we explain how that adds to the wear and list the top repair as a separate item.
Where stone repair starts for homes in Homestead
For a stone chimney in Homestead, we start in the same place every time: identify the stone and what holds it, then find where water gets in. There is no charge for the inspection, and you get the estimate in writing. Tell us what you have noticed so far, and the visit is planned around it.
From there, we reset, replace and repoint only what you approve. Opened areas are sheltered overnight, and the site is left clean when the work ends. You receive a written record listing each stone and joint we worked on.
Stone work we can include in the scope
- Replacement stones blended with the originals
- Scratch coat or lath repair behind adhered veneer
- Gentle cleaning of mortar smears
- Sealant joints at changes of material
Your stone chimney questions
Why not just glue a loose stone back in place?
Adhesive is not a substitute for a proper mortar bed on an exterior wall. A glued stone can let go again, and the glue can block the drainage behind it. We reset stones the way the assembly was meant to hold them.
Why did stones on my chimney come loose?
Common causes include poor mortar coverage behind the stones, water in the backing, corroded lath or ties, and movement. The stone that came off often shows which cause applies, so we look closely at its back.
Will the repaired area stand out from the rest of the chimney?
New mortar and fresh stone faces can look brighter at first. We blend by reusing original stones where possible and matching the joints. The difference tends to soften as the repair weathers.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo