Skip to content
(645) 465-4171

Chimney parging and stucco repairs in Palmetto Estates

The water source is found first, so the new stucco is not left to fail below an open leak.

  • Owned and run locally
  • Available for same-day service
  • Fully licensed and insured
  • Family owned and run

How failing chimney stucco shows itself

  • Paint peeling on one chimney face
  • A long crack near the roof line
  • Weep screed buried under soil or paving
  • Gaps where stucco meets the roof
Jump to

Stucco repair details that decide the result

The thin stucco finish that carries texture

The finish coat is the layer you see. It is thin, and it holds the texture and often the color of the wall. It is also where a repair is most likely to stand out.

Tell us whether the chimney has been painted or whether the color is in the plaster itself. An integrally colored finish is harder to match on a small patch than a painted one. We explain which situation you have and what the finished repair is likely to look like before you approve it.

Checking the old coating before adding a new one

A new coating has to bond to what is already on the wall. The International Masonry Institute recommends knowing the type of existing coating and testing how well it adheres before any recoating project.

For a chimney, that can mean a small test area and a check of whether the old coating lifts. If it does, it needs removing where it has failed. We tell you what the test shows and how it affects the scope, rather than coating over a surface that is already letting go.

Mixing only the stucco that can be used

Stucco starts to stiffen soon after it is mixed. The National Park Service advises mixing only as much as can be used within a working period and discarding the rest rather than adding water to loosen it.

Retempered plaster is weaker and can craze or crack. We mix small batches for chimney patches, sized to the area in hand. The same care applies to overmixing, which that guidance links to crazing, discoloration and poor bonding. It is a small discipline that shows in the finished repair.

The order of work on a stucco repair

A stucco repair follows a sequence, and each step depends on the one before. Water sources come first, then removal of loose plaster, then repair of the base, lath or barrier.

After that come the scratch coat, the leveling coat and the finish, each given time to cure. Paint, if it is part of the job, comes last. The estimate lists these steps in order, so you can see where each visit fits and why the work is spread out the way it is.

Stucco work we separate on the estimate

  • Finish coat texture matched
  • Roof junction where stucco meets flashing
  • Paint on repaired areas where included
  • Open top covered at each day's end

What people ask about chimney stucco

How many visits does a stucco repair usually take?

Usually more than one, because each coat needs to cure before the next goes on. The exact plan depends on the size of the repair and the weather. We set out the likely sequence in the estimate, and the curing gaps do not change the agreed price.

Why does the stucco near the ground keep breaking down?

The lowest part of the wall often stays wet from splashing rain, irrigation, soil piled against it or a buried weep screed. We check the base conditions and suggest changes you can make, alongside any repair we price.

What does the workmanship warranty cover on stucco work?

It covers the work we did in the areas we repaired. It does not cover damage from a separate defect you chose not to repair, or plaster we did not touch. We explain the terms before you approve the estimate.

Proudly American

Local service. Careful repairs. A fireplace worth coming home to.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Send your details for a free Miami chimney or fireplace inspection. We will call to confirm the appointment.

Chimney & Fireplace Brands We Work With