Ventless gas logs, pilots and burners repaired in Coral Ridge
Vent-free service that respects the safety pilot, the room size rules and the listing of the host fireplace.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Clues that the ODS pilot or burner needs attention
- Pilot goes out during use
- Remote stopped lighting the fire
- Unit unused for a long stretch
- Uneven or delayed burner lighting
Jump to
The work behind a vent-free fireplace visit
No spark at a vent-free pilot
A piezo igniter should throw a visible spark at the pilot each time the button is pressed. No spark usually means a broken or loose wire, an electrode that has moved or cracked, or a worn igniter. On electronic models, weak batteries can do it.
We check the wire, the electrode position and the igniter against the manual. Do not bend the electrode yourself or pry at the pilot hood. The pilot is a precise assembly, and a small shift can affect both lighting and the oxygen sensing.
Smoke from vent-free logs after break-in
Light smoke during break-in is expected. Smoke later on is not. The troubleshooting charts link it to logs out of place, flame striking a log, dirty ports or foreign material on the burner.
Turn the unit off if you see smoke once break-in is over. We reset the logs, clean the burner and remove anything that does not belong. Then we run the unit long enough to confirm the smoke has stopped, and the written record says what we changed.
The host fireplace must allow vent-free logs
A vent-free log set may go only into a fireplace that allows it. For factory-built fireplaces, the residential volume of the Florida Building Code sets a clear rule. Unvented gas logs belong there only when the fireplace itself has been tested, listed and labeled for them. Some fireplace manuals say outright that the unit was not tested with unvented burners.
We read both labels, the log set's and the fireplace's, before servicing the logs. If the host does not allow them, we explain that plainly. Servicing a set in a fireplace that forbids it is not a repair we can offer.
The codes behind vent-free gas service
Vent-free service draws on the fuel gas volume of the Florida Building Code, the fireplace chapter of its residential volume and the maker's manual. The appliance standard behind the listing sits under all three. None of them is a matter of taste.
We work from those documents on every visit in Coral Ridge. When a question depends on how a code section applies to your home, we explain what the section says. Where a building official has the final word, we tell you that too.
Your ventless fireplace repair scope in writing
- Log positions reset to the diagram
- Bedroom or bathroom location review
- Leak check on disturbed joints
- Written record of the work
Questions about vent-free fireplace service
What should I do if I smell gas near the unit?
Leave the house with everyone inside, without lighting anything or touching switches. Once you are outdoors, call your gas utility or 911 and follow their instructions. Stay out until they clear the house, and keep the fireplace off afterward.
Can a vent-free fireplace be used after it was under water?
Not until it has been inspected. The manuals say to replace any part of the control system and any gas control that has been under water. We identify those parts from the maker's list and price them before any work.
Can my ventless unit be converted from propane to natural gas?
Some vent-free models state that field conversion is not permitted, and the unit must burn the gas on its rating plate. Where the maker offers a correct replacement for the other fuel, we explain it. We do not alter orifices on our own.
More Ways to Care for Your Fireplace
- Top-Sealing Damper InstallationFit a top-mounted damper only after checking the fireplace, product restrictions and control route.
- Gas Fireplace InstallationCreate a complete gas fireplace installation plan for the room, appliance and connected systems.
- Firebox RepairRepair the damaged fireplace chamber using an approach suited to masonry or manufactured components.
- Gas Fireplace VentingAssess and repair the gas fireplace vent arrangement using components suited to the identified system.
- Smoke Chamber RepairRepair identified smoke-chamber surfaces with the access and material requirements clearly defined.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo