
Breathable waterproofing for chimney brick in Riverland Village
A yes to the treatment inside 72 hours of your free inspection means 10% off that work.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When chimney masonry may need a repellent in Riverland Village
- Flaking or crumbling brick faces
- Glossy patches from an earlier coating
- Brick grit collecting on the roof below
- A sealing quote with no product named
Jump to
Keeping rain from soaking into chimney brick
Stucco and water repellents
Some repellents list stucco among their suitable surfaces, and others do not. A stucco chimney also has its own ways of taking on water, through cracks, around trim and at the top. Those have to be dealt with before treatment is considered.
If your chimney is finished in stucco, we check the finish for cracks and hollow spots first. Where a repellent suits the stucco, the product data says so. Where an elastomeric or other finish is more appropriate, that belongs to stucco repair, and we explain the difference.
Choosing a product with a track record
Brick industry guidance recommends products that have performed well on similar brick, in similar exposure, over a meaningful period. A new or untested product may look fine at first and behave differently later.
We use products whose makers publish full technical data, including the surfaces they suit and their limits. Our estimate names the product, and its data sheet is yours to read. If you have a product in mind, tell us, and we will explain whether it suits your chimney.
Faces that stay dark after rain
Before any treatment, the way a chimney dries after rain tells us a lot. Faces that stay dark for a long time are absorbing more water than the rest. That may be the face that takes the weather, or it may be porous brick or open joints.
If you can, look at the chimney a few hours after rain and note which faces stay dark. Tell us when you book. It helps us decide which faces need treatment and where to look for repairs first.
Questions to raise at the visit in Riverland Village
A waterproofing visit in Riverland Village is a good time to ask anything you are unsure about. It helps to have your questions ready, such as whether the brick really needs treatment and what should be repaired first.
You might also ask how the product will look, how long preparation will take and what happens if it rains. We answer each in plain words. If a question needs checking, such as how an old coating will behave, we tell you how we will find out.
Written into a waterproofing proposal
- Cap or open flue noted at the top
- Roof junction flashing condition
- Sealant joints replaced and cured first
- Application method from the data sheet
Questions about chimney waterproofing
What does the workmanship warranty cover on a treatment?
Our warranty applies to the workmanship, meaning the cleaning, masking and application set out in the written record. Faces outside the agreed scope, and later cracks from other causes, fall outside it. Ask before you approve how a future problem would be looked at.
Does waterproofing cover the inside of the flue or the firebox?
No. The treatment goes on the outside masonry only. The flue, smoke chamber and firebox face heat and combustion gases rather than rain, and masonry repellents are not made for that exposure. Interior problems belong to a different service, and we can note what we see.
What if an earlier coating is already on the brick?
We try to identify it and test how the surface responds. Some coatings stop a new repellent from soaking in, and a glossy film may be holding moisture. If the old coating has to come off, that is a separate item with its own method and test.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo